固浪大板外墻瓷磚背膠
瀏覽： 發布日期：2023-01-09
固浪大板外墻背膠
產品規格：10KG
本產品是一種采用進口原料和先進技術配方科學生產的聚合物高分子膠結材料，適用于低吸水率的大板、薄板、瓷質系列等大尺寸瓷磚背面的界面處理，能有效提高瓷磚鋪貼效果，減少瓷磚空鼓、掉磚等現象。經過嚴格測試，大板專用背膠各項指標均達到國內先進水平，具有良好的滲透性、粘結力、耐水性能、耐老化性能且采用凈味技術，屬綠色環保材料，它能賦予大尺寸瓷磚優良的粘結性能，保證瓷磚鋪貼后的安全，是理想的大尺寸瓷磚鋪貼背膠產品。
This product is a kind of polymer cementitious material produced scientifically with imported raw materials and advanced technical formula. It is suitable for the interface treatment of the back of large-size ceramic tiles such as large plate, thin plate and porcelain series with low water absorption. It can effectively improve the tile paving effect and reduce the hollowing and falling of tiles. After strict testing, all indicators of the special backing glue for large board have reached the domestic advanced level. It has good permeability, adhesion, water resistance and aging resistance, and adopts the clean taste technology. It is a green environmental protection material. It can endow large-size ceramic tile with excellent adhesion and ensure the safety of ceramic tile after paving. It is an ideal backing glue product for large-size ceramic tile paving.
適用范圍：
適用于低吸水率的大板、薄板、瓷質系列等（尺寸600mm×1200mm以上）大尺寸瓷磚背膠的界面處理。
Suitable for large plate, thin plate, porcelain series with low water absorption (size 600mm) × Interface treatment of back glue of large size ceramic tile (above 1200mm).
產品優點：
粘結性強、快速粘結
Strong adhesion and fast adhesion
強耐候性、強耐水性、持久性好
適用于低吸水率的大板、薄板、瓷質系列等（尺寸600mm×1200mm以上）大尺寸瓷磚背膠的界面處理。
Suitable for large plate, thin plate, porcelain series with low water absorption (size 600mm) × Interface treatment of back glue of large size ceramic tile (above 1200mm).
產品優點：
粘結性強、快速粘結
Strong adhesion and fast adhesion
強耐候性、強耐水性、持久性好
Strong weather resistance, strong
water resistance and good durability
降低空鼓率
Reduce hollowing rate
施工便捷、安全環保
降低空鼓率
Reduce hollowing rate
施工便捷、安全環保
Convenient construction, safety and
environmental protection
使用說明：
1、提前7天把鋪貼基面用水泥砂漿找平，砂漿干固7天后進行瓷磚鋪貼；
2、準備相關工具，清理基面污漬和疏松顆粒，然后用基面加固劑在鋪貼基面滾涂1至2
遍，待干固后進行下一道工序施工；
3、把攪拌好的瓷磚膠或水泥砂漿均勻抹上墻，用鋸齒刮板進行拉槽，注意保持鋸齒刮
板角度的一致性，確保拉槽高度一致；
4、清理大板背面的脫模劑、油污、粉塵等雜物；
5、打開包裝桶，用電攪拌器或灰刀攪拌2至3分鐘，有少許顆粒，不影響使用，開放時
間為8小時；
6、使用專用刮板將攪拌好的背膠均勻刮涂到瓷磚背面，如有未攪拌開的顆粒，需壓散
刮開；
7、刮涂好背膠的瓷磚面與水泥砂漿應在15分鐘內粘合，嚴禁等干鋪貼；
8、清除大板瓷磚四周溢漿和表面污漬，建議留縫鋪貼，用找平器調平瓷磚。
1. Level the paving base surface with cement mortar 7 days in advance, and lay the tiles after the mortar is dry for 7 days;
2. Prepare relevant tools, clean the base surface stains and loose particles, and then use the base surface reinforcement agent to roll on the base surface for 1 to 2
After it is dry and solidified, the next process construction is carried out;
3. Spread the mixed tile glue or cement mortar evenly on the wall, use a sawtooth scraper to pull the groove, and pay attention to keep the sawtooth scraping.
The consistency of the plate angle ensures that the height of the pull groove is consistent;
4. Clean up the release agent, oil, dust and other debris on the back of the large plate;
5. Open the packaging barrel and stir with an electric mixer or a gray knife for 2 to 3 minutes. There are a few particles, which will not affect the use.
8 hours;
6. Use a special scraper to evenly apply the stirred back glue to the back of the tile. If there are unstirred particles, they need to be scattered.
scrape off;
7. The tile surface and the cement mortar should be bonded within 15 minutes, and it is strictly forbidden to wait for dry paving;
8. Remove the overflowing slurry and surface stains around the large tiles. It is recommended to leave seams to pave and use a leveler to level the tiles.
1、使用過程中，嚴禁加水或其它物質；
2、背膠批刮厚度保持2mm較宜，盡量批刮均勻，瓷磚背面留1-2cm不批刮背膠，以免鋪
貼時溢出沾污瓷磚；
3、 背膠刮涂后盡快與水泥砂漿粘合，以保證其化學粘結效果；
4、避免粘結砂漿與背膠層或基面粘結面積不夠?qū)е驴展摹⒚撀洌?/span>
5、不得在瀝青基類防水基面、丙綸防水層、膩?zhàn)拥葟?qiáng)度差的界面，刮涂背膠后鋪貼瓷磚；
6、存放于陰涼干燥處（5-45℃）未開封可保存18個月；
7、本產品不能在5℃以下施工。
1. During use, it is strictly forbidden to add water or other substances;
2. The thickness of the back glue batch should be kept at 2mm, and the batch should be scraped as evenly as possible. Leave 1-2cm on the back of the tile and do not batch the back glue to avoid spreading.
Spilled and stained tiles when pasting;
3. The adhesive should be bonded with cement mortar as soon as possible after scraping to ensure its chemical bonding effect;
4. Avoid insufficient bonding area between the bonding mortar and the adhesive layer or the base surface, resulting in hollowing and falling off;
5. Do not lay tiles on the interface with poor strength such as asphalt-based waterproof base surface, polypropylene waterproof layer, putty, etc. after scraping and applying adhesive;
6. Stored in a cool and dry place (5-45 ℃) unopened can be stored for 18 months;
7. This product cannot be constructed below 5°C.
參考用量：
涂刷厚度在2mm左右，使用量為0.25-0.3kg/m2。
The thickness of the brush is about 2mm, and the usage is 0.25-0.3kg/m2.
參考用量：
涂刷厚度在2mm左右，使用量為0.25-0.3kg/m2。
The thickness of the brush is about 2mm, and the usage is 0.25-0.3kg/m2.
保質期：
原裝密封產品在干燥陰涼的環境下存放。在正常的儲存和運輸條件下，產品的保質期為二年。
Shelf life:
The original sealed product is stored in a dry and cool environment. Under normal conditions of storage and transportation, the shelf life of the product is two years.
全國免費服務熱線：400-843-6198
