固柔韌型防水涂料

 Strong wave flexible waterproof coating

產品概述Product Overview：

固浪K11防水漿料柔韌II型(廚衛專用）采用瑞士進口原材料，運用瑞士固浪最新環保防水漿料技術，是雙組份聚合物改性柔性防水材料，粉料與添加劑混合，使用后得到富柔韌性的防水膜，與混凝土及砂漿有良好的粘附力，能與之形成緊密牢固的永久性結合。

Gulang K11  waterproof  paste  flexible  type II (for kitchen and bathroom) uses Swiss imported raw materials. using the latest environmental protection of Swiss solid waves  Waterproof  slurry  technology  is a  two-component polymer modified flexible waterproof  material. The powder is mixed with  additives and used. To the flexible and flexible  waterproofing  membrane,  it has good adhesion to concrete and mortar, and can form a tight and firm Long-term combination.

產品特點Product characteristics：

1. 柔韌型，可覆蓋不大于2mm裂痕 ;
2. 適用于長期浸水環境 ;
3. 潮濕區域可直接施工 ;
4. 可使用在室外 , 具有良好的耐候性 ; 
5. 特別適用于墻角 , 管道周邊及易滲水部位 ;
6. 凈味配方、綠色環保 ;

Flexible, can cover not more than 2mm cracks, suitable for long-term immersion environment, wet area can be directly constructed, can be used in outdoor, with good weather resistance, especially suitable for corner, pipeline peripheral and pervious parts; Clean flavor formula, green environmental protection;

施工工藝Construction Technology：

1.清理基面，并充分濕潤；

2.產品雙組份配比為粉料 : 液料=1 : 0.41（質量比）；將液料倒入干凈的攪拌容器

中，然后按比例一邊攪拌一邊緩慢加入粉料，充分?jǐn)嚢?-5分鐘直至成無粉團。

均勻的膠漿，建議使用機械攪拌，以取得最佳的攪拌效果；

3.用輥筒、刷子將漿料均勻涂刷于處理好的底材上，刷完一層后，待其略干固

（剛好不沾手）再刷第二層；

4.養護固化；防水層施工完成48小時后，進行閉水試驗（溫度較低或通風不良時，

可適當延遲進行）。

1. Clean and moisten the base surface. 2. The two-component ratio of the product is powder: liquid material = 1:0.41(mass ratio) ; pour the liquid material into a clean mixing container, then add the powder slowly while stirring according to the ratio, and stir thoroughly for 3-5 minutes until the powder is free. Uniform Mortar, suggest the use of mechanical mixing, in order to achieve the best mixing effect; 3. Use roller and brush to brush the slurry evenly on the treated substrate. After brushing one layer, wait until it is a little dry (just don't touch hands) and then brush the second layer. 4. Curing and curing; 48 hours after construction of waterproof layer, conduct water-tight test (when the temperature is low or poor ventilation, can be appropriately delayed) .

參考用量Reference dosage：

防水涂膜厚度在1.5mm，用量約為1.5-2.0kg/m2（實際用量視基面的實際情況以及所需求的防水層厚度而定）

The thickness of waterproof film is 1.5 mm, and the dosage is about 1.5-2.0 kg/m2(the actual dosage depends on the actual condition of the base surface and the required waterproof layer thickness)

注意事項Points to note：

1、施工溫度應在5-35℃之間，避免雨天作業；

2、基層表面應清理干凈，平整、堅實、無浮灰、無0.3MM以上裂縫。寒冷地區或低溫

      條件下請注意產品防凍儲存。添加劑儲存溫度不低于0℃

3、本產品含有水泥，可能會引起皮膚過敏，操作時最好戴上手套。

4、本產品無需加水，開桶攪拌均勻后直接使用。

5、因施工操作失誤或沒有按照產品說明規范施工等引起質量問題本公司不負任何責任。

1. The construction temperature should be between 5-35 ° C to avoid working in rainy days 2. The surface of the base should be cleaned clean, flat, solid, no floating ash, no cracks over 0.3 mm. In cold area or low temperature, please pay attention to antifreeze storage. Additive storage temperature not less than 0 ° C 3, this product contains cement, may cause skin allergies, it is best to wear gloves when operating. 4, this product does not need to add water, open the barrel to stir evenly after direct use. 5. The company shall not be responsible for any quality problems caused by construction operation mistakes or failure to follow the specifications of the product specifications.

保質期Expiration date：

原裝密封產品在干燥陰涼的環境下存放。在正常的儲存和運輸條件下，產品的保質期為一年。

The original sealed product is stored in a dry and cool environment. Under normal conditions of storage and transportation, the shelf life of the product is one years.

全國免費服務熱線：400-843-6198      www.xzlqcc.com

?